This is a Race-only product. An electronically signed Race-only Product Acknowledgement Agreement is required prior to shipping out. The use or installation of this product outside of the intended closed circuit racing purpose may be illegal under the Federal Clean Air Act (42 U.S.C. § 7522(A)(3)). Instructions for the waiver will follow after checkout.
Product Information
Unitronic Stage 3 TCU Performance Transmission Tune For C8 Audi RS6/RS7 4.0TFSI
Unitronic Stage 3 TCU Performance Software for the AL952 8-speed ZF gearbox is calibrated for use specifically with Unitronic's Stage 3 ECU Performance Software. Performance Software for your TCU Box Code is subject to availability.
Simple Installation
UniCONNECT+ gives you the freedom to effortlessly install your Unitronic Performance ECU and DSG Software from the comfort of your own home or garage.*
Unitronic recommends the use of these battery chargers to ensure, uninterrupted, trouble-free, flashing at home!
UniCONNECT+ is a Programming and Diagnostic Interface which gives users the freedom to reflash their Engine Control Unit (ECU) or Transmission Control Unit (TCU) from the comfort of their own garage. With the ability to upgrade the Unitronic Performance Software, flash back to stock, and also perform diagnostics, UniCONNECT+ is a complete end-user programming and diagnostic interface that provides control over your vehicle.
Change Software Maps
Quickly and Easily re-flash your ECU with Performance Software maps designed and specifically calibrated to suite the hardware and fuel modifications or fuel grade used.
Data Logging
Gathering high resolution data is made easy with Unitronic’s pre-configured channel loadouts for fast and effortless troubleshooting and data logging.
Simple back to factory restoration
UniCONNECT+ makes it painless to revert your ECU back to it’s stock calibration within minutes.*
Features
Unitronic Engineers identified gearbox originating torque limitations on the TCU side of the AL952 trasmission. In order to overcome these limitations, while ensuring proper torque management and operation, a TCU Performance Software was required to run Unitronic Stage 3 ECU Performance Software for TTE1020 Turbochargers.
Stage 3 TCU Performance Software calibrations necessarily increase the torque limiter to 1300Nm for seamless torque management and harmonious operation with the corresponding Unitronic ECU calibrations and further enhance the user experience.
Does this Fit Your Car?
