Water / Methanol injection solution for your VW / Audi 1.8T!!
Recommended for K03/K04 turbo applications. If running a larger turbo, please click here.
Tired of your factory SMIC heat soaking? Want to push your 1.8T without the fear of detonation? Get better IAT reduction and detonation control with this new 1.8T-specific kit. The Digital Variable Control unit proportionally injects more or less water-methanol according to input signals from your factory Mass Air Flow sensor. This offers accurate injection for small, quick spooling turbos. Enjoy more power over a wide range with smooth, seamless delivery.
• Digital MAF referenced controller
• UHO pump for the most in pressure and volume
• Bulkhead fitting required to tap into factory washer reservoir
• 10 feet of tubing
• 2 nozzles to cover a wide range of horsepower
• All required hardware needed for installation
• 1.8T specific instructions for ease of installation
Low Level Indicator
The indicator switch upgrade includes an LED and an EZ installation grommet for use with any Boost Cooler® reservoir or can be added to any plastic reservoir including factory windshield washer fluid tanks.
Shut off solenoid is used when mounting the injection nozzle lower than the reservoir or the reservoir is rear-mounted to prevent gravity flowing. It is also used to prevent siphoning when the injection nozzle is mounted after the throttle body or carburetor and is exposed to vacuum.
Boost Juice™ is Snow Performance’s proprietary mix of 49% methanol and 51% water. It is made in a controlled environment with special care to make sure the ratios are accurate to result in a high performance water-methanol fluid formulated for use in the Boost Cooler™ injection system. Boost Juice is required as the exclusive fluid for lifetime warranty.
*NOTE* Boost Juice CAN NOT be shipped outside of the United States. Boost Juice CAN ONLY be shipped using Ground service.